SuperEndo Inlay Preparation Burs Kit

• Durable Burs with multi-layer coating.
• Silicon inside hold burs tightly
• Full set autoclavable.
• Evenly distributed diamond particles
• Sturdy built

• Shank type - Friction grip
• Construction - Stainless steel Shank Coated with diamond particles
• Autoclavable upto 134°C 

Color band on shank:

• Regular - Blue
• Fine - Red
• Superfine - Yellow

Set Of 10 Piece 

• SI-48
• DI-42
• FO-22EF
• EX-21EF
• SF-21
• TF21F
• TF-31
• TF-22
• SF-21F
• EX-18F

1 X 10 Burs in SuperEndo Inlay Preparation Burs Kit

• Insert the instrument as deeply as possible into the chuck (Friction Grip).
• Set the handpiece at the required working speed before applying the instrument to the treated area.
• Apply a maximum operating force of 0.4 [N] and do not exceed a speed of 230'000 [rpm].
• Activate water spray during the entire treatment (minimum 50 mL/min).
• Regulate water flow in case of water excess or shortage.
• It is recommended to use a dental dam.
• Use the instruments over the entire length of their working part and not just at the tip, so as to avoid an unconscious increase of the contact pressure causing local overheating.
• Once the preparation has been completed, remove the instrument from the site and allow it to come to a standstill.
• It is recommended to wear gloves and safety glasses. 
• After use, remove the bur to clean and sterilize according to protocol.
• Do not use the bur if its bent or if the surface diamond coating has worn- off.

• Country of Origin : Made in PRC

• Manufacturer/Importer has No Warranty as applicable for this product.
• Oralkart and the Buyer acknowledge that the Products purchased/used are a subject matter of original Manufacturer/Importer’s warranties only
• Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and Oralkart may assist the customer in registering a request to get the Product replaced or serviced. 
• The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact or not altered in any manner or has not tampered as the case may be.

Question: Can these burs be autoclaved ?
Answer: Yes, these burs indeed come in a packaging that can be autoclaved and the burs can be reused thereafter.

Question: What should I do to prevent instrument fracture ?
Answer: Avoid jamming or levering actions when rotating, as this increases the risk of instrument breakage. Never exceed the specified maximum speed. Avoid applying forces greater than the recommended values, as this could cause damage to the instrument and the treated area. Always Check for possible damages; dispose of oxidized, blunt and eccentric instruments.

Question: When to dispose these Inlay Preparation Burs ?
Answer: Check for possible damages; dispose of oxidized, blunt and eccentric instruments.