Kalabhai Labstone 3Kg

• General purpose laboratory stone.
• Produces smooth, strong cast.
• Low setting expansion for accuracy.
• High compressive strength.

Physical Properties:

• Colour: Bright Yellow
• Type: Class lll
• Water/Plaster Ratio: 34ml/100g
• Working time: 5 Minutes
• Mixing Time: 15 seconds
• Setting Time: 7-10 Minutes
• Setting Expansion: 0.15%

Comprehensive Strength:

• After 1 hour: 220 kg/cm square
• After 24 hour: 500 kg/cm square

•  1 x Lab Stone 3Kg

• Prepare Workspace: Ensure your work area is clean and free from debris. Gather all necessary equipment and materials.
• Measure Water: Measure 34ml of water per 100g of Kalabhai Labstone powder. Accurate measurement is crucial for optimal results.
• Mixing: Gradually add the measured water to the Kalabhai Labstone powder while continuously mixing. Use a spatula or mixer to achieve a creamy consistency.
• Mixing Time: Mix the water and powder for approximately 15 seconds or until homogenous. Avoid over-mixing, as this can affect the properties of the stone.
• Pouring: Once mixed, pour the prepared Kalabhai Labstone into the impression or mold promptly. Ensure even distribution to capture all details accurately.
• Setting Time: Allow the poured material to set undisturbed for 7-10 minutes. Avoid any unnecessary vibrations or movements during this time.
• Demolding: After the setting time has elapsed, carefully demold the cast. Be gentle to avoid damaging delicate features.
• Finishing: Once demolded, trim any excess material and finish the cast as needed for its intended purpose, whether it be for denture models, flasking procedures, or crown and bridge basing.
• Curing: Allow the cast to fully cure according to the recommended time frames before proceeding with further procedures.

• Country of Origin: India
• Manufacturer: Kalabhai Karson Pvt. Ltd.

• Warranty is not applicable for this product.

Question: Can I use Kalabhai Labstone 3Kg for crown and bridge models?
Answer: Yes, Kalabhai Labstone 3Kg is suitable for basing crown and bridge models, offering a creamy mix and superior hardness.

Question: What is difference between kalabhai Labstone and diestone ?
Answer: Kalabhai Lab Stone is a Type III dental plaster, while diestone is a Type IV dental plaster with higher strength. Kalabhai Lab Stone is suitable for various dental applications like formation of secondary cast for complete denture, general purpose study models, while diestone, being stronger, is specifically used for working dies in crown, implant, post, or prosthesis fabrication.

Question: Can I use Kalabhai Labstone 3Kg for crown and bridge models?
Answer: Yes, Kalabhai Labstone 3Kg is suitable for basing crown and bridge models, offering a creamy mix and superior hardness.

Question: What is the setting time for Kalabhai Labstone 3Kg?
Answer: The setting time is approximately 7-10 minutes, allowing you ample time to work with the material.

Question: How do I mix Kalabhai Labstone 3Kg properly?
Answer: Measure the recommended water-to-plaster ratio (34ml per 100g) and mix for 15 seconds. Follow the provided instructions for best results.

Question: What is Kalabhai Labstone 3Kg used for?
Answer: Kalabhai Labstone 3Kg is designed for various dental applications, including making models, flasking, producing full or partial dentures, and basing crown and bridge models.